3D Bioplotter Research Papers

Displaying all papers about VA-086 (3 results)

Development of a Photocrosslinkable Methacrylated Methylcellulose and Gelatin bioink for Cartilage Tissue Regeneration

MACE PGR Conference 2020

Articular cartilage disease can cause pain, mobility issues, and disability. Clinical treatment includes microfracture, subchondral drilling, graft transplantation, and eventually total joint replacement implant. However, these approaches can present specific problems and limitations. Three-dimensional (3D) bioprinted scaffolds utilising hydrogels can provide a suitable 3D biochemical and biophysical environment, thus is a promising strategy for cartilage tissue therapy and regeneration. This study aims to develop a new hydrogel bioink with improved printability, mechanical, and biological properties for cartilage regeneration. A photocrosslinkable methacrylated methylcellulose (MCMA) and gelatin (GelMA) hybrid bioink is evaluated in this preliminary investigation. The results showed that methylcellulose and…

In-situ handheld 3D Bioprinting for cartilage regeneration

Journal of Tissue Engineering and Regenerative Medicine 2017 Volume 12, Issue 3, Pages 611-621

Articular cartilage injuries experienced at an early age can lead to the development of osteoarthritis later in life. In situ 3D printing is an exciting and innovative bio-fabrication technology that enables the surgeon to deliver tissue- engineering techniques at the time and location of need. We have created a hand- held 3D printing device (Biopen) that allows the simultaneous co-axial extrusion of bioscaffold and cultured cells directly into the cartilage defect in vivo in a single session surgery. This pilot study assesses the ability of the Biopen to repair a full thickness chondral defect and the early outcomes in cartilage…

The 3D printing of gelatin methacrylamide cell-laden tissue-engineered constructs with high cell viability

Biomaterials 2014 Volume 35, Issue 1, Pages 49–62

In the present study, we report on the combined efforts of material chemistry, engineering and biology as a systemic approach for the fabrication of high viability 3D printed macroporous gelatin methacrylamide constructs. First, we propose the use and optimization of VA-086 as a photo-initiator with enhanced biocompatibility compared to the conventional Irgacure 2959. Second, a parametric study on the printing of gelatins was performed in order to characterize and compare construct architectures. Hereby, the influence of the hydrogel building block concentration, the printing temperature, the printing pressure, the printing speed, and the cell density were analyzed in depth. As a…